Graco 25A693 Instructions Manual page 28

Installation and Wiring
Variable Frequency Frequency Drive/Inverter
Variable Variable Frequency
This section contains steps to set up connections to
the Graco Variable Frequency Drive/Inverter (B).
Graco Variable Frequency Drives/Inverters include
parts 17N041, 17N042, and 17N043. For complete
warnings and operation instructions for Graco
Variable Frequency Drives/Inverters and agitator
wiring, see the Variable Frequency Drives manual
3A4793, the Electric Direct Drive Agitator manual
3A4553, the Electric Driven Back-Gear Drum
Agitators manual 3A4548, and the manufacturer's
manual.
Digital Digital Input Digital Input Input Configuration Configuration Configuration
Improper wiring may cause electric shock or other
serious injury if work is not performed properly.
All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations.
For Lenze SMVector, install the wiring at the Variable
Frequency Drive/Inverter as follows:
1. Connect the Variable Frequency Drive/Inverter
jumper wires.
Figure 24 Variable Frequency Drive/Inverter
Jumper Wires
Termi- Description
Termi- Termi- Description Description
nal nal nal
1 Digital Input:
Start/Stop
2 Analog
Common
5 Analog Input:
0...10 VDC
28
Drive/Inverter Connections Connections
Drive/Inverter Connections
Note
Note Note
Input resistance =
4.3 kΩ
Input resistance: >
50 kΩ
Termi- Termi- Termi- Description Description Description
nal
nal nal
6 Internal DC
supply for
speed pot
25 Analog Input:
4...20 mA
4 Digital Refer-
ence/Common
11 Internal DC
supply for
external
devices
13A Digital Input:
Configurable
with P121
13B Digital Input:
Configurable
with P122
13C Digital Input:
Configurable
with P123
14
Digital Output:
Configurable
with P142, 144
30 Analog Output:
Configurable
with
P150...P155
16
Relay Output:
Configurable
17
with P140,
P144
2. Perform the Variable Frequency Drive/Inverter
configuration as specified in
Variable Frequency Drive/Inverter for Modbus
Communication, page
See Appendix D: Communication Configuration,
page 154, for configurations specific to either an
Allen Bradley PowerFlex drive or a Mitsubishi
drive/inverter.
Note Note Note
+10 VDC, max 10
mA
Input resistance =
250 kΩ
+15 VDC / 0 VDC,
depending on
assertion level
+12 VDC, max 50
mA
Input resistance =
4.3 kΩ
DC 24 V / 50 mA;
NPN
0...10 VDC, max. 20
mA
AC 240V / 3 A
DC 24V / 2
A...240V / 0.22
A, noninductive
Set Up a Lenze
54.
3A4030C