Graco 25A693 Instructions Manual page 68

Using the Setup Screens
Set Up Up E E E - - - Flo Flo DC DC Pumps
Set Set Up Flo DC
After turning on node communication to each
component, each pump in the system must be
individually configured. (Typically, each station
contains one pump used to circulate fluid throughout
that station.)
Figure 66 E-Flo DC Setup Screen
1. Press on any Run screen to enter the Setup
menu screen.
2. Press E-Flo E-Flo DC E-Flo DC. DC
3. On the E-Flo DC Setup screen, press the Station
Number field.
Number Number
Station Number Number keypad, enter the number
4. On the Station Station Number
of the station to be configured.
The number in the field is the station that is being
configured in the following steps. The station
name is displayed directly below the station
number.
68
Pumps
Pumps
Station Station
Use this procedure to specify the pump installed in
one specific station. If the system contains multiple
stations, use this procedure separately for the pump
in each station.
5. Press each item's response field and use the
keypad that displays to specify the equipment
used in the selected station. For a list of fields,
see Fields on the E-Flo DC Setup
NOTE: For a newly-created station, all fields read
No No or None No None. None
6. Repeat steps 3–5 for each additional pump in the
system.
Screen.
3A4030C