Graco 25A693 Instructions Manual page 73

Set Up Up Primary Primary Tanks Tanks
Set Set Up Primary Tanks
Each station contains one Primary Tank (G) , which
provides the fluid that is pumped throughout the
circulation system. Every Primary Tank must be
individually configured.
Use this procedure to specify the Primary Tank
installed in one specific station. If the system contains
multiple stations, use this procedure separately for
the Primary Tank in each station.
Figure 68 Primary Tank Screen
1. Press on any Run screen to enter the Setup
menu screen.
Primary Tank Tank.
2. Press Primary Primary Tank
3. On the Primary Tank screen, press the Station
Number Number Number field.
4. On the Station Station Number Station Number keypad, enter the number Number
of the station to be configured.
The number in the field is the station that is
being configured. The station name is displayed
directly below the Station Number.
3A4030C
NOTE: When Tank Volume is configured (see NOTE: NOTE:
Configure Primary Tank Volume, page
screen displays the estimated volume with the
tank level percentage. When the Tank Volume is
not configured, only the tank level percentage is
displayed.
5. Press each item's data field and use the keypad
that displays to specify the equipment used in
the selected station. For a list of fields, see
Fields on the Primary Tank Setup
NOTE: For a newly-created station, all fields read
NOTE: NOTE:
No No or None No
Station
Station
6. Repeat steps 3–6 for each additional station in
the system.
Using the Setup Screens
None. None
77), the
Screen.
73