Graco 25A693 Instructions Manual page 128

Events and Logs
E-Flo DC DC Errors Errors
E-Flo E-Flo DC Errors
Display Applicable
Display Display Applicable Applicable
Code Code Code Motor Motor Motor
None Basic
None Basic and
Advanced
A4N_
CAC_ Advanced
CAD_ Advanced
CAG_
Advanced
C3G_
C4G_ Advanced
CBN_ Basic and
Advanced
CCN_ Basic and
Advanced
END_ Basic and
Advanced
ENN_ Advanced
E5F_ Advanced
Advanced
E5S_
E5U_ Advanced
EBC_ Advanced
F1F0
F2F0
K1D_ Advanced
K2D_ Advanced
K3D_ Advanced
K4D_ Basic and
Advanced
128
Blink Type
Blink Blink Type Type
Code Code Code
6 Alarm
The Mode Select knob is set between Pressure
Flow
9 None A blink code of 9 is not an error code, but an indicator of
which pump is active.
6 Alarm The motor current exceeded 13A or the hardware overcurrent
tripped at 20A.
None Alarm The display detects a loss of CAN communication. Flashing
alarm appears on the display, and the blink code occurs.
2–3 Alarm Unit detects a loss of CAN communication. This alarm is only
logged. No flashing alarm appears on the display, but the
blink code does occur.
2–3 Deviation The PLC has stopped pinging the register for the solenoid.
None Deviation The display detects a loss of Modbus communication when
Modbus deviation is enabled on Setup Screen 16.
None Alarm The display detects a loss of Modbus communication when
Modbus alarm is enabled on Setup Screen 16.
2–4 Deviation Temporary circuit board communication failure.
3–6 Alarm Circuit board communication failure.
5–6 Advisory A calibration of the encoder and stroke range is in progress.
None Advisory Dual lower system calibration completed successfully.
None Advisory Dual lower system calibration error. System running too
rapidly to perform calibration.
None Advisory Dual lower system calibration stopped or interrupted.
None Advisory Dual lower system calibration unsteady. System could not
determine optimum setting.
None Advisory Run/Stop switch in Stop position (closed).
None Alarm Fill pump flow not detected. The Primary Tank level has not
increased with the no flow timeout window and the no flow
timeout event is set to alarm.
None Deviation Fill pump flow not detected. The Primary Tank level has not
increased with the no flow timeout window and the no flow
timeout event is set to deviation.
1–2 Alarm Flow is below minimum limit.
None Deviation Flow is below minimum limit.
None Deviation Flow exceeds maximum target; also indicates pump runaway
condition exists.
1 Alarm Flow exceeds maximum target; also indicates pump runaway
condition exists.
Description
Description Description
. Set the knob to the mode you want.
and
3A4030C