Graco 25A693 Instructions Manual page 52

Software Setup
Configure the the Radar Radar Level
Configure Configure the Radar
Use this procedure to configure Graco part numbers
25D298 and 25D294 (Endress+Hauser FMP50
Radar Level Sensors).
NOTE: NOTE: For complete warnings and operation NOTE:
instructions, see the manufacturer's manual that is
shipped with the product.
Key Name Name Function
Key Key Name Function Function
-
Minus For menus and submenus, press
key this key to move the selection bar
up in a list.
For text and numeric fields, press
this key to move the selection bar
to the left (backward).
+
Plus For menus and submenus, press
key this key to move the selection bar
down in a list.
For text and numeric fields, press
this key to move the selection bar
to the right (forward).
E Enter Press this key to enter the setup
key screen (main menu).
Press this key for two seconds to
open the context menu.
Press this key to open the selected
menu, submenu, or parameter.
Press the key for two seconds to
open the help text for the selected
parameter.
For text and numeric fields, press
this key to open the selected group
or perform the selected action.
Press the key for two seconds on a
selected parameter to confirm and
enter the edited parameter value.
-
Es- For menus and submenus, press
and
cape these two keys to exit the current
+
key menu level and go to the next
higher level.
For help text, press these two
keys to close the help text for a
parameter.
Press these two keys for two
seconds to return to the home
screen.
For text and numeric fields, press
these two keys to close the editor
without applying changes.
52
Level Sensor Sensor
Level Sensor
Press E E E to enter the setup screen, press + + + to highlight
the setup menu, and then press E E E to enter the setup
menu. Enter the setup information for each screen.
Setup Screen Setup Setup Screen Screen Function Function Function
Device tag
Enter a unique name for the
measuring point.
Distance unit Select the distance unit for
calibration:
• Meters (default)
• Millimeters
• Feet
• Inches
Tank type Select the tank type:
• Metallic
• Bypass/pipe
• Non-metallic
• Mounted outside
• Coaxial
NOTES:
The Medium Medium type
for these options to be available.
Depending on the probe, some
options might not be available or
additional options might appear.
For coax probes and probes with
a metallic center washer, the tank
type corresponds to the type of
probe and cannot be changed.
Medium group Select the medium group to
specify the dielectric constant
(DC) of the medium:
• Water based (DC >=4)
• Others
NOTES:
The Medium Medium type
for these options to be available.
The Medium
changed later; however, the
Medium Medium group Medium
The measuring range can be
reduced for small dielectric
constants.
Empty
Enter the distance (LN) between
calibration the process connection (LR) and
the minimum level (0%).
Medium type must be Liquid type Liquid Liquid
Medium type type must be Liquid Liquid Liquid
Medium property property can be
Medium property
group group remains the same.
3A4030C