Graco 25A693 Instructions Manual page 64

Using the Setup Screens
Configure Each Each Station
Configure Configure Each
When the stations have been created
( Create the Stations, page
must be individually configured.
Figure 63 Station Configuration Screen
1. Press on any Run screen to enter the Setup
menu screen.
Station Configuration Configuration.
2. Press Station Station Configuration
3. On the Station Configuration screen, press the
Station Station Number Station Number field. Number
NOTE: For a newly created station, all fields on
the Station Configuration screen contain No
None.
None None
Station Number Number keypad, enter the number
4. On the Station Station Number
of the station to be configured.
64
Station
Station
63), each station
No or No
Use this procedure to specify the equipment installed
in one specific station. If the system contains multiple
stations, use this procedure separately for each
station.
5. One at a time, press each item's response field
and use the keypad to specify the equipment
used in the selected station.
For a list of field descriptions, see
Fields on the Station Configuration
6. A node ID is automatically generated for each
paint kitchen component that communicates
directly with the Intelligent Paint Kitchen software.
Make a note of each node ID and the component
for which it was created. Enter each ID
its component, following the instructions in
Enter the Node IDs, page
7. Repeat steps 3–6 for each additional station in
the system.
Screen.
44.
3A4030C