Graco 25A693 Instructions Manual page 56

Software Setup
Variable Frequency Frequency Drive/Inverter
Variable Variable Frequency
On each primary Variable Frequency Drive/Inverter
and secondary Variable Frequency Drive/Inverter,
use the control panel to enter the node ID that was
assigned when the station was configured.
Example: Lenze Variable Frequency Drive/Inverter
control panel shown.
Press to access the Variable Frequency
Drive/Inverter menu. See
Frequency Drive/Inverter for Modbus Communication,
page 54 to set the Variable Frequency Drive/Inverter
56
Drive/Inverter Nodes Nodes
Drive/Inverter Nodes
Set Up a Lenze Variable
parameters as required for use with the Intelligent
Paint Kitchen. See the manufacturer's instructions
for complete menu descriptions and information.
NOTE: Entering the correct node ID into each NOTE: NOTE:
Variable Frequency Drive/Inverter allows the
Intelligent Paint Kitchen software to communicate
with each Variable Frequency Drive/Inverter. It does
not tell the Variable Frequency Drive/Inverter the
speed of each agitator motor during operation. You
can use the Intelligent Paint Kitchen software to
enable or disable each agitator in a station and to
set its operating speed.
NOTE: Each Lenze Variable Frequency Drive/Inverter
NOTE: NOTE:
must have a jumper installed. For connection
information, see Variable Frequency Drive/Inverter
Connections, page 28. If the Variable Frequency
Drive/Inverter was purchased from Graco, the jump
is pre-installed. But if the Variable Frequency
Drive/Inverter was purchased from a different
supplier, you must install the jumper.
3A4030C