Graco 25A693 Instructions Manual page 69

Table 5 5 5 Fields Fields on on the the E E E - - - Flo
Table Table Fields on the
Field Field Field Description Description Description
Station Number The current station number being displayed:
• 1–Maximum number of stations
Station Name The alphanumeric name of the current station being displayed:
• 0–20 characters
Local / Remote Select Local
Control hazardous location.
Select Remote
in the non-hazardous location.
System Type Pump type is automatically detected and displayed: Single Lower or Dual Lower.
Pressure Units Select the units for the pressure of the pump:
• psi psi psi
• Bar Bar Bar
• MPa MPa MPa
Volume Units Select the units for the volume data of the pump:
• Liters Liters Liters
• Gallons Gallons Gallons
• cc cc cc
Flow Units Select the units for the pressure flow data of the pump:
• Liters/min Liters/min: Liters per minute Liters/min
• Gallons/min Gallons/min: Gallons per minute Gallons/min
• cc/min cc/min: Cubic centimeters per minute cc/min
• oz/min oz/min: Ounces per minute oz/min
• Cycles/min Cycles/min: Cycles per minute Cycles/min
Agitator Speed Select the units for the agitator speed of the pump or tank:
Units
• % % %
• Hz Hz Hz
• RPM RPM RPM
Stop BPR % Enter a number (0–100) to specify the percentage of back pressure regulation to hold
fluid line pressure when the pump is stopped.
Remote Enable/Disable the Remote Run/Stop function.
Run/Stop
Closed Loop Enable/Disable the Closed Loop Control.
Control
Lower Size The pump lower size is automatically detected and displayed in cubic centimeters: 220
cc, 290 cc, 750 cc, 1000 cc, 1500 cc, 2000 cc, 3000 cc, or 4000 cc
Auxiliary I/O Select the function:
Function
• Reed Reed Switch Reed
• Agitator Agitator Halt Agitator
pump control automatically disables the primary agitator.
High Level
• High High
the high level setting in percent.
• Low Low Level Low
level setting in percent.
• PLC PLC: Output control by a remote source. PLC
3A4030C
Flo DC DC Setup Setup Screen Screen
Flo DC Setup Screen
Local to control the selected pump from the Pump Control Module in the
Local
Remote to control the selected pump from the Intelligent Paint Kitchen software Remote
Switch Switch Count Count: Used to count the cycle rate of the fill pump. Count
Halt: When the pressure switch attached to the tank cover elevator closes, the Halt
Level Primary Primary: Enables output when the Primary Tank level is greater than
Level Primary
Level Primary Level Primary: Enables output when the Primary Tank level is less than the low Primary
Using the Setup Screens
69