Graco 25A693 Instructions Manual page 61

Using the the Setup Setup Screens
Using Using the Setup
Initial setup of an Intelligent Paint Kitchen requires
you to enter the physical specifications of your
stations and their components into the Intelligent
Paint Kitchen software:
• Create and name each station (required).
• Enter specifications of every component of each
station (required).
• Create and enter node IDs to allow the Intelligent
Paint Kitchen software to communicate with the
station components (required).
• Enter operating specifications for each pump and
agitator (required).
• Create profiles for every pump, Variable Frequency
Drive/Inverter, and agitator in the system
(required). Multiple profiles allow the Intelligent
Paint Kitchen software to select the profile that
causes a component to operate as needed for
current conditions.
• Lock or unlock access to the setup parameters
(optional).
• Set a password (optional).
Button
Button Button
Station
Configuration
Node
Communication
E-Flo DC
Tank Control
Primary Tank
Secondary Tank
Profiles
Scheduler
3A4030C
Screens
Screens
Description
Description Description
Press to display the Station Configuration screen, used to set up each station
in the Intelligent Paint Kitchen installation. Use this screen to specify the
components that are installed, and node IDs where needed. Follow the procedure in
Configure Each Station, page
Press to display the Node Communication screen, used to perform these functions:
• Set up pump control nodes. See
• Set up tank control nodes. See
• Set up Variable Frequency Drive/Inverter nodes. See .
Press to display the Pump Setup screen, used to set up each pump's specifications
and units of measure, and those of the agitator and back pressure regulator
associated with each pump. Also, use to specify whether each pump is controlled
locally or remotely. Follow the procedure in
Press to display the Pumpless Setup screen, used to set up units of measure for
each Secondary Tank and its associated agitator. Also, use to specify whether
each pneumatic remote transfer pump is controlled locally or remotely. Follow the
procedure in Set Up Tank Control Modules, page
Press to display the Primary Tank Control Setup screen, used to set operating units
and parameters for supplying fluid from the Secondary Tank to the Primary Tank.
Follow the procedure in
Press to display the Secondary Tank Control Setup screen, used to set operating units
and parameters for supplying fluid from the Primary Tank to the Secondary Tank.
Follow the procedure in
Press to display the Profiles screen, used to create multiple profiles
that specify operating parameters for each pump in the system. See
Create Pump Profiles, page
Press to display the Production Scheduler screen, used to create productions
schedules for the system. See
Using the the Setup
Using Using the
Most system setup tasks are accessed through the
Setup Menu screen.
Press on any Run screen to enter the Setup
menu screen.
If the system has a password lock, the Password
screen displays. See
Use instructions on the following pages to access
and perform setup functions from the Setup Menu. In
general, a new Intelligent Paint Kitchen system is set
up by clicking the Setup Menu buttons. Start at the
upper left with Station Configuration and complete
each row, working from left to right.
64.
Pump Control Module Nodes, page
Tank Control Module Nodes, page
Create Pump Profiles, page
Set Up Tank Control Modules, page
Set Up Tank Control Modules, page
85.
Set Up Production Schedule, page
Using the Setup Screens
Setup Menu Menu
Setup Menu
Enter Password, page
45.
71.
71.
71.
89.
95.
45.
85.
61