Graco 25A693 Instructions Manual page 129

Display Applicable
Display Display Applicable Applicable
Code Code Code Motor Motor Motor
L1A0
L2A0
L4A0
L6CA
L6CB
MND_ Advanced
P1D_ Advanced
P9D_ Advanced
P1I_ Advanced
P2I_ Advanced
P3I_ Advanced
P4I_ Advanced
P5DX Advanced
P6CA or Advanced
P6CB
P6D_ Advanced
T2D_ Basic and
Advanced
T3D_ Basic and
Advanced
T4D_ Basic and
Advanced
V1I_ Basic and
Advanced
V2I_ Basic and
Advanced
V1M_ Basic and
Advanced
V3I_ Basic and
Advanced
3A4030C
Blink Type
Blink Blink Type Type
Code Code Code
None Alarm The flow rate is above the current profile flow limit set on
Profile Screen 3.
None Deviation The Primary Tank level is below the Primary Tank level low
deviation set point.
None Alarm The Primary Tank level is above the Primary Tank level high
alarm set point.
None Deviation Port 8 is enabled and the current draw is less than 4 mA.
The Back Pressure Regulator is requesting a value greater
than 0%.
None Deviation Port 9 is enabled and the current draw is less than 4 mA.
None Advisory Maintenance counter is enabled and countdown reached
zero (0).
None Deviation Unbalanced load. Dual Lower system — P1D1 = Motor 1 is
requiring less force to hold speed; pump lower may need
service. P1D2 = Motor 2 is requiring less force than motor
1 to hold speed.
None Deviation Major unbalanced load — see P1D_ (P9D_ is higher
magnitude)
1–3 Alarm Pressure is below minimum limit.
None Deviation Pressure is below minimum limit.
None Deviation Pressure exceeds maximum target.
1–4 Alarm Pressure exceeds maximum target.
None Deviation More than one pump is assigned to a transducer. The
assignment for that transducer is automatically cleared under
this condition. User must reassign.
None Deviation For units without closed loop pressure control: Transducer
(A or B) is enabled but not detected.
1–6 Alarm For units with closed loop pressure control: Transducer is
enabled but not detected.
3–5 Alarm Internal thermistor disconnected or motor temperature is
below 0° C (32° F).
5 Deviation Motor over temperature. Motor will throttle itself to stay below
85° C (185° F) internally.
4–6 Alarm Motor over temperature. Motor will throttle itself to stay below
85° C (185° F) internally.
2 Alarm Brown out; voltage supplied to motor is too low.
None Deviation Brown out; voltage supplied to motor is too low.
2–6 Alarm AC power is lost.
None Deviation Voltage supplied to motor is too high.
Events and Logs
Description
Description Description
129