Graco 25A693 Instructions Manual page 130

Events and Logs
Display Applicable
Display Display Applicable Applicable
Code Code Code Motor Motor Motor
V4I_ Basic and
Advanced
V9M_ Basic and
Advanced
WCW_ Advanced
Basic and
WMC_
Advanced
WNC_ Basic and
Advanced
WNN_ Advanced
WSC_ Advanced
WSD_ Advanced
WXD_ Basic and
Advanced
130
Blink Type
Blink Blink Type Type
Code Code Code
3 Alarm Voltage supplied to motor is too high.
7 Alarm Low supply voltage detected at start up.
None Alarm System type mismatch; motor is an E-Flo DC dual lower
system and the display configuration does not match.
Change the display's system type on the Setup Units screen
(screen 15).
4–5 Alarm
Internal software error.
3–4 Alarm Software versions do not match.
None Alarm System type mismatch; motor is an E-Flo DC single lower
system and the display configuration does not match.
Change the display's system type on the Setup Units screen
(screen 12 in dual lower mode).
None Deviation Profile is set to 0 pressure or 0 flow.
1–5 Alarm Invalid lower size; occurs if the unit is operated before setting
up the lower size.
4 Alarm An internal circuit board hardware failure is detected.
Description
Description Description
3A4030C