Graco 25A693 Instructions Manual page 38

Installation and Wiring
Connect Pump Pump and and Tank
Connect Connect Pump and
Use fiber optic cables to connect each fiber optic
converter to a Pump Control Module (PD). If
the paint kitchen contains both a Pump Control
Module and a Tank Control Module (TD), connect
them together using a fiber optic cable. See the
Cable Lengths table.
1. Disconnect the power.
2. Connect the Tank Control Module (if used) in the
hazardous location to the Pump Control Module,
also in the hazardous location:
a. Plug the two connectors at one end of cable
(FA) into Port 1 and Port 2 on the Tank
Control Module.
b. Plug the two connectors at the other end
of cable (FA) into Port 5 and Port 6 on the
Pump Control Module.
Figure 38
Tank
Tank Tank
Control Control Control
Module Module Module
Pump Pump Pump
Control
Control Control
Module Module Module
38
Tank Control Control Modules Modules to to to the
Tank Control Modules
Hazardous Location Hazardous Hazardous Location Location
the Supervisor Supervisor Box
the Supervisor
3. Connect the Pump Control Module in the
hazardous location to a fiber optic converter
in the Supervisor Box in the non-hazardous
location:
a. Plug the two connectors at one end of cable
(FB) into Port 1 and Port 2 on the Pump
Control Module.
b. Plug the two connectors into the RX and TX
Ports on a fiber optic converter inside the
Supervisor Box.
Wire Wire Wire
Box
Box
Color Color Color
Orange with red ends
Orange with black
ends
Non Non- - - hazardous Non hazardous hazardous
Location
Location Location
3A4030C