Graco 25A693 Instructions Manual page 85

Create Pump Pump Profiles Profiles
Create Create Pump Profiles
Every pump installed in a station is used to constantly
circulate fluid through the paint kitchen. The pump
speed or output pressure varies, depending on
the conditions within the system or the current
operational status of the station.
For example, one profile might be set up and used
when the paint system is in production mode, where
high flow rate or pressure is needed to accommodate
one or more paint sprayers. A second profile might
be created for use when the paint system is in
non-production mode, where a low flow rate or
pressure is needed to circulate paint through the
system.
Figure 74 Profiles Screen
4. On the E-Flo DC Profiles screen, press the
Station Number Station Station Number field. Number
3A4030C
Using the Setup Screens
Use this procedure to create up to four profiles for
each pump. Each profile determines how a pump
performs under a set of specified conditions.
1. Press on any Run screen to enter the Setup
menu screen.
2. Press Profiles Profiles. Profiles
3. On the Profiles screen, press Pump
Station Number Number keypad, enter the number
5. On the Station Station Number
of the station to be configured.
The number in the field is the station that is
being configured. The station name is displayed
directly below the station number.
Pump. Pump
85