Graco 25A693 Instructions Manual page 49

Set Set Set Up Up Up Pump Pump Control Pump Control Module Control
Use the Pump Control Module (PD) keypad and
display to set up configurable inputs and outputs.
1. Press the Toggle key to enter the Setup screens
of the Pump Control Module.
2. Use the Up Arrow and Down Arrow keys to
navigate to Setup Screen 16.
Option Option Option
Reed Switch
Agitator Halt Drum
Cover Switch
Primary Tank High
Alarm Output
3A4030C
Module Configurable Module Configurable I/O Configurable
Icon Icon Icon Screen Screen Screen
I/O I/O
3. Press the Enter Screen key to enter the screen
and edit the settings.
4. Use the menu next to the I/O icon
the option for the connected peripheral.
Function Function Function
Configures Port 4 pin 4 as an
input to allow a reed switch to be
connected.
The current reed switch cycle rate
appears next to the cycle rate icon
Configures Port 4 pin 4 as an input
to allow a pressure switch to be
connected. If the drum cover is lifted
while this configuration is properly
connected, the agitator shuts down.
The current input status
appears in the agitator status
field
Module is required for this function.
Configures Port 4 pin 4 as an output
to allow for the connected device to
receive an alarm when the volume
of the Primary Tank is above the
value that is defined in the Primary
Tank High field
value is a percentage of the total
volume of the Primary Tank.
Select the manual output
box
to control the output manually. After
you release the button, the manual
activation is terminated.
Software Setup
to select
in cycles per minute.
. A Supervisor
and hold the button
. This
49