Graco 25A693 Instructions Manual page 66

Using the Setup Screens
Name Each Each Station Station
Name Name Each Station
When the stations were created using the Intelligent
Paint Kitchen software (
each station was given a unique number. For
example, if your installation contains ten stations, the
stations are numbered 1 through 10.
Give each station a descriptive name. Typically, each
station's name is that of the paint color or fluid used
at that station (Red, Blue, Light Grey, and so on).
Be certain that you know which physical station
is represented by each station number. This is
determined by which Supervisor Box (A) and which
fiber optic converter each station is physically
connected to.
Figure 64 Primary Tank Screen
1. Press on any Run screen to enter the Setup
menu screen.
Station Name Name field. NOTE:
2. Press the Station Station Name
must be unlocked for you to enter the station
name.
3. Use the Station Station Station Name Name keyboard to enter a name Name
for the selected station.
NOTE: NOTE: Station names can include upper-case NOTE:
and lower-case letters, spaces, numerals,
and special characters. Press Shift to access
upper-case letters, then press More to access
special characters.
66
Create the Stations, page
NOTE: The screen
NOTE:
For example, if your system has 14 paint kitchens,
63), stations 1–10 might be connected to the Supervisor
Box, and stations 12–14 might be connected to the
Expansion Box.
NOTE: These instructions assume that you have
NOTE: NOTE:
connected a fiber optic cable from each station to
a fiber optic converter before creating and naming
the stations. You could also do this in the opposite
order by first creating the stations in the Intelligent
Paint Kitchen software, then naming each station,
and then connecting each fiber optic converter to
the corresponding station. Each physical station
must be connected to the one fiber optic converter
that matches the station number generated by the
software.
4. When you have finished typing the station name,
press Return
5. Repeat steps 3–6 for each station that has been
created.
6. After naming all the stations, go
to Configure Each Station, page 64
continue setting up the system.
.
to
3A4030C