Graco 25A693 Instructions Manual page 46

Software Setup
Control Control Module Control Module Module Software Software Software
Pump Control Modules and Tank Control Modules
located in each hazardous location can be set up
locally, using the keypad and display to access and
change the software settings.
Use the control module software to:
• Place the control module in Remote Control
mode. See Set Up a Pump Control Module
for Modbus Communication, page 47
Set Up a Tank Control Module for Modbus
Communication, page
• Set the baud rate for control module
communication. The baud rate must match
the baud rate of the Supervisor Module.
See Set Up a Pump Control Module for
Modbus Communication, page 47
Set Up a Tank Control Module for Modbus
Communication, page
• Set up the Reed Switch, Agitator Halt Drum Cover
Switch, Primary Tank High and Low Alarm Output,
and Auxiliary Solenoid. See
Module Configurable I/O, page 49
Tank Control Module Configurable I/O, page
• Enter the unique node ID generated by the
Intelligent Paint Kitchen software for the control
module. See Configure Each Station, page
See the E-Flo DC Control Module Kit manual 3A2527
or the Tank Control Module Kit manual 3A5991
for complete warnings and operating instructions,
including how to use the keypad to access and
change the software settings.
Figure 46 Control Module Keypad and Display
46
and
48.
and
48.
Set Up Pump Control
and Set Up
51.
64.
Key Key Key Name Name Name Function Function Function
Toggle Toggle between Run screens
and Setup screens.
Error Clear alarm after cause has
Reset been fixed. When there is no
alarm to clear, this key sets
the active pump's profile to
Stop. Also used to cancel data
entered and return to original
data.
Up Ar- Move between screens or fields
row- on a screen, highlight data
/Down to change, or to increase or
Arrow decrease the digits in a field.
Enter Activate a field for editing or
accept the highlighted selection
on a menu.
Enter Highlight data that can be
Screen edited. Also can change the
function of the Up/Down arrows
so they move between data
fields on the screen, rather than
between screens.
Exit Exit data editing.
Screen
3A4030C