Graco 25A693 Instructions Manual page 71

Set Up Up Tank Tank Control Control Modules
Set Set Up Tank Control
Each station may contain a Secondary Tank (H),
used to provide fluid to the Primary Tank (G).
Secondary Tanks may have any or all of a Radar
Level Sensor (T), Agitator (R), and Pneumatic
Remote Transfer Fill Pump (N) used to control the
fluid supply operation. That set of components must
be configured for each station.
Figure 67 Tank Control Setup Screen
1. Press on any Run screen to enter the Setup
menu screen.
Tank Control Control Module
2. Press Tank Tank Control
3. On the Tank Control Setup screen, press the
Station Number Number field.
Station Station Number
4. On the Station Station Station Number Number Number keypad, enter the number
of the station to be configured.
The number in the field is the station that is being
configured in the following steps. The station
name is displayed directly below the Station
Number.
Table 6 6 6 Fields Fields on on the the Tank Tank Control
Table Table Fields on the Tank
Item Description
Item Item Description Description
Station Number The current station number being displayed:
• 1–Maximum number of stations
Station Name The alphanumeric name of the current station being displayed:
• 0–20 characters
3A4030C
Modules
Modules
Module.
Module
Control Setup Setup Screen Screen
Control Setup Screen
Using the Setup Screens
Use this procedure to specify the Secondary Tank
components installed in one specific station. If the
system contains multiple stations, use this procedure
separately for each station.
5. Press each item's response field and use the
keypad that displays to specify the equipment
used in the selected station. For a list of fields,
see Fields on the Tank Control Setup
NOTE: For a newly-created station, all fields read
No No or None No None. None
6. Repeat steps 3–6 for each additional station in
the system.
Screen.
71