Table of Contents
Advertisement
3. Replace the server cover. For more details, see
4. Take the ESD strap off.
5. Plug in the peripheral devices and Ethernet cables, connect the AC power cords,
Replacing the power supply
The 600r has only one power supply. You must power down the server to replace the power
supply.
Important:
Do not remove the power supply while the system is running. Power down the system and
unplug the power supply before removing the power supply. After you power down the
server, allow the power supply to cool for several minutes.
To replace the power supply
1.
2. Remove the server cover. For instructions, see
3. Remove the PCI riser assembly. For instructions, see
4. Lift up the rear of the power supply until it clears the two half-circle stops at the
5. While holding the rear of the power supply above the stops, push back at the front of
Avaya CallPilot® 600r Server Maintenance and Diagnostics
cover
on page 74.
and restart the server.
Voltage:
Risk of electric shock
High current inside the chassis can cause severe injury.
After you power down the server, allow the power supply to cool for several minutes.
cover
on page 74.
page 82.
rear of the power supply. See letters A and B in
supply
on page 78.
the power supply to disconnect it from the power board. See (C) in
Removing the power supply
Removing and replacing the server
Removing and replacing the server
Figure 17: Removing the power
on page 78.
Replacing the power supply
Replacing the MPB96 card
Figure 17:
December 2010
on
77
Advertisement
Table of Contents
