Mounting The 1145B2/1146B2 Power Supply - Avaya S8700 Installation Instructions Manual

Installing and wiring telephone power supplies

Mounting the 1145B2/1146B2 power supply

Figure 92, 1145B2/1146B2 mounting arrangement,
and wall-mounting plates fit together.
the expanded power supply components (power distribution unit and "T" cable).
A manual switch on the distribution unit allows the user to redirect reserve power to outputs 1 through 32
so all outputs are provided battery reserve power or to outputs 1 through 8 to provide high power above
6.25 watts.
The 1145B22/1146B2 is a -48 V power supply with 275 watts total output. Each output circuit is current
limited by a Polymer Positive Temperature Coefficient Resistance Device (PTC) that limits the maximum
output to 12 watts. Each 1146B2 output has an LED to indicate the status of the PTC. If the LED is on,
the PTC has a short on that power pair.
Not all outputs can simultaneously provide 12 watts. The average power per output cannot exceed 8.6
watts (275/32 = 8.6). The 1145B22 is designed to power one ISDN terminal or DCP adjunct per output.
The maximum number of terminals or adjuncts is 32 at less than or equal to 6.25 watts each. The
1145B22 is required for installations outside the United States.
Auxiliary power (local or bulk) is always required for the following:
•
Attendant Console 302D
•
PassageWay adapter interface
230
Figure 93, Expanded power distribution unit,
NOTE:
The switch must be set to the 1-32 position.
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
on page 231 shows how the standard power supply
on page 232 shows
December 2003