Setting The Arming - YOKOGAWA TA220 User Manual

4.6

Setting the Arming

Procedure
KEY
LOCK SEC RANGE
IM 704610-01E
Display 2
Display 1
ns ms s
% V
%/
S
Selecting Auto Arming (Internal Arming)
Press ARMING to turn OFF both the
Selecting External Arming and Setting the Arming Delay
• Procedure A
1. Press ARMING and select
illuminates.
2. Press SHIFT+ARMING (DELAY). ArmDelay appears in Display 2, and the
setting value appears in Display 1.
3. Use rotary knob & < > to set the delay time.
• Procedure B
To enter the delay time using the procedure below, you must turn display of
DispDly ON when selecting numerical value display (see section 5.2).
You can set the delay time while viewing the measured jitter ratio on Display 1.
1. Press MEASURE to display Dly in Display 2.
2. Press ARMING and select
illuminates. At the same time, the delay time is shown on Display 2.
3. Use rotary knob & < > to set the delay time.
<<For a functional description, see section 2.4>>
L.MARK R.MARK
DISP OFF
MEASURE
E2T
JUDGE
PW
GO
BD x1 D to C
NO-GO GATE TIME DELAY BLOCK
FUNCTION
MEDIA ARMING INHIBIT
SHIFT SHIFT REMOTE STORE UTILITY
10%
LOCAL RECALL ENTER
20%
LEVEL
JDG LEVEL COUPLE EQ BOOST
S
POLARITY TRIG IMPEDANCE EQUALIZER
50 Ω
AUTO MAN 1M Ω CONV
SEC RANGE
SCALE
and
or . The indicator of the selected item
or . The indicator of the selected item
The phrase, "rotary knob & <>"
is used in the following
explanation to instruct the user
to enter numerical setting values
using the knob and arrow keys.
For details on this procedure,
see section 3.7.
indicators.
4-9
4