Table of Contents
Advertisement
7.1 DC Output of Jitter Ratio
7-2
Setting the Jitter Ratio Determination Level
For the procedure for setting the jitter ratio determination level, see section 5.3.
Setting the Average coefficient of the DC Output Filter
4.
Turn the rotary knob to select DC ave.
5.
Press > (or ENTER). Display 1 blinks.
6.
Use rotary knob & < > to set the average coefficient.
7.
Press ENTER.
Setting the Jitter Ratio Correction Coefficient
• Setting the α Coefficient
4.
Turn the rotary knob to select Coeff•α.
5.
Press > (or ENTER). Display 1 blinks.
6.
Use rotary knob & < > to set the correction coefficient α.
7.
Press ENTER.
• Setting the β Coefficient
4.
Turn the rotary knob to select Coeff•β.
5.
Press > (or ENTER). Display 1 blinks.
6.
Use rotary knob & < > to set the correction coefficient β.
7.
Press ENTER.
If you press MEASURE during entry of settings or upon completion thereof, the settings
entered up to that time are applied to the DC output settings, and measurement is
restarted.
IM 704610-01E
Advertisement
Table of Contents
