Recalling Setup Information - YOKOGAWA TA220 User Manual

6.2

Recalling Setup Information

Procedure
KEY
LOCK
Explanation
6-2
Display 2
Display 1
ns ms s
%
SEC RANGE
%/
S
Selecting the Memory Number
1. Press RECALL. Recall appears in Display 2, and the memory number of the
recall source appears in Display 1.
2. Turn the rotary knob to select the memory number.
Executing the Recall
3. Press ENTER. The word donE is displayed for approximately one second, and
the setup information is recalled. Then, the measurement is started using the
recalled setup information.
Setup Information That Is Recalled
The setup information that is stored at the specified preset number is recalled, and the
current settings are replaced with this information. If no setup information is stored in the
internal memory of the specified memory number, the factory default settings are
recalled.
Number of Sets That Can Be Recalled
The number of sets that can be recalled (memory numbers) is seven from 0 to 6.
L.MARK R.MARK
DISP OFF
V
MEASURE
E2T
JUDGE
PW
GO
BD x1 D to C
NO-GO GATE TIME
MEDIA FUNCTION
SHIFT SHIFT REMOTE
10%
LOCAL
20%
JDG LEVEL LEVEL
S
POLARITY TRIG
AUTO MAN
SEC RANGE
SCALE
The phrase, "rotary knob & <>"
is used in the following
explanation to instruct the user
to enter numerical setting values
using the knob and arrow keys.
For details on this procedure,
see section 3.7.
DELAY BLOCK
ARMING INHIBIT
STORE UTILITY
RECALL ENTER
COUPLE EQ BOOST
IMPEDANCE EQUALIZER
50 Ω 1M Ω
CONV
IM 704610-01E