Connecting To The Network - YOKOGAWA TA220 User Manual

9.2

Connecting to the Network

Cable
When Connecting to a PC on the Network
When Making a 1-to-1 Connection with a PC
9-2
Connect a UTP (unshielded twisted-pair) cable or STP (shielded twisted-pair) cable from
a hub or other adapter to the 100BASE-TX port on the rear panel of the instrument.
ETHERNET 100BASE-TX port
RJ-45 modular jack
Be sure to use one the following cables for connection.
• UTP (Unshielded Twisted-Pair) cable (category 5 or better)
• STP (Shielded Twisted-Pair) cable (category 5 or better)
100BASE-TX compatible adapter (hub or router)
TA220
UTP cable or STP cable
100BASE-TX compatible adapter (hub or router)
TA220
UTP cable or STP cable
(straight cable)
Note
• When using a UTP cable or STP cable (straight cable), be sure to use a category 5 or
better cable.
• Avoid connecting the PC directly to the TA220 without going through the hub or router.
Operations are not guaranteed for communications using a direct connection.
PC
(straight cable)
PC
Network adapter card
LINK Indicator
Illuminates when the link between the
port on the TA220 and the connected
device is established and communication
is mutually possible.
ACT Indicator
Illuminates when packet transmission is
normal.
Network adapter card
IM 704610-01E