Entering Numerical Values - YOKOGAWA TA220 User Manual

3.7

Entering Numerical Values

Procedure
Explanation
IM 704610-01E
Display 2 Display 1
KEY
ns ms s
LOCK SEC RANGE
%/
S
1. Confirm that Display 1 or 2 is displaying numerical values, and that only one of
the digits of the displayed values is blinking.
2. Press an arrow (< or >) key to select the digit you wish to change. The
numerical value or underbar at the selected digit blinks.
3. Turn the rotary knob to set the value within the range of each item. As the
value of the selected digit is increased, the next higher digit is also increased
accordingly. Likewise, as the value of the selected digit is decreased, the next
lower digit is also decreased accordingly.
You can set the numerical value within the range of each item. You can confirm that the
TA220 is ready to accept numerical values when a single digit of the numerical value on
the display is blinking.
Note
You can reset the specified numerical value to the initial value (factory default setting). For
details, see section 11.2.
L.MARK R.MARK
DISP OFF
% V
MEASURE
E2T
JUDGE
PW
GO
BD x1 D to C
NO-GO GATE TIME DELAY
MEDIA FUNCTION ARMING
SHIFT SHIFT REMOTE STORE
10%
LOCAL RECALL
20%
JDG LEVEL LEVEL COUPLE
S
POLARITY TRIG IMPEDANCE EQUALIZER
AUTO MAN 50 Ω
SEC RANGE
SCALE
BLOCK
INHIBIT
UTILITY
ENTER
EQ BOOST
1M Ω CONV
3-11
3