Communication Interface - YOKOGAWA TA220 User Manual

Item
Clock signal output (CLOCK OUT)
Connector type
Output impedance
Output coupling
‡‡†
Output level
† The typical value is a representative or standard value. It is not strictly guaranteed.
†† The D-to-C high speed calculation function is not available on products with suffix code -BDS.
‡ When the monitor equipment receives the signal at high impedance (approx. 1 MΩ).
‡‡ Measured value under standard operating conditions as described in General Specifications after the warm-up time has
elapsed.
‡‡† When the monitor equipment receives the signal at 50 Ω.

13.6 Communication Interface

GP-IB
Item
Electrical and mechanical
specifications
Functional Specifications
Protocol
Encoding
Mode
Address
Clear remote mode
Ethernet
Item
Connector type
Number of ports
Electrical and mechanical
specifications
Transmission system
Max. transmission rate:
Protocol
Port number
Supported services
IM 704610-01E
13.5 Input/Output on the Rear Panel/13.6 Communication Interface
Specifications
BNC
†
50 Ω (typical value )
DC
Approximately ±0.4 V
Specifications
Conforms to IEEE St'd.488-1978 (JIS C1901-1987).
SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT1, C0, and E1.
Compliant with IEEE St'd 488.2-1992
ISO (ASCII)
Addressable mode
0–30
Remote mode can be cleared using the LOCAL key (except during Local Lockout).
Specifications
RJ-45
1
Conforms to IEEE 802.3
100BASE-TX/10BASE-T
100 Mbps
TCP/IP
10001/tcp
DHCP
13
13-5