Chapter 6 Storing And Recalling Setup Information; Storing Setup Information - YOKOGAWA TA220 User Manual

Chapter 6 Storing and Recalling Setup Information
6.1

Storing Setup Information

Procedure
KEY
LOCK SEC RANGE
Explanation
IM 704610-01E
Display 2 Display 1
ns ms s % V
%/
S
Selecting the Memory Number
1. Press SHIFT+RECALL (STORE). Store appears in Display 2, and the memory
number of the store destination appears in Display 1.
2. Turn the rotary knob to select the memory number.
Executing the Store
3. Press ENTER. The word donE is displayed for approximately one second, and
the setup information is stored. When the storing operation is finished, the
display once again shows measured results.
Information That Is Stored
All settings other than communication related settings are stored to the internal memory.
Number of Sets That Can Be Stored
The number of sets that can be stored (memory numbers) is seven, from 0 to 6.
Note
If you initialize all setup information of the TA220 to factory default settings (see section 11.2),
the stored setup information is also initialized. The setup information of all seven sets is reset
to the factory default condition.
L.MARK R.MARK
DISP OFF
MEASURE
E2T
JUDGE
PW
GO
BD x1 D to C
NO-GO GATE TIME DELAY BLOCK
MEDIA FUNCTION ARMING INHIBIT
SHIFT SHIFT REMOTE STORE UTILITY
10%
LOCAL RECALL ENTER
20%
JDG LEVEL LEVEL COUPLE EQ BOOST
S
POLARITY TRIG IMPEDANCE EQUALIZER
AUTO MAN 50 Ω 1M Ω CONV
SEC RANGE
SCALE
The phrase, "rotary knob & <>"
is used in the following
explanation to instruct the user
to enter numerical setting values
using the knob and arrow keys.
For details on this procedure,
see section 3.7.
6-1
6