YOKOGAWA TA220 User Manual page 146

Code Message
148 Character data not allowed
150 String data error
151 Invalid string data
158 String data not allowed
161 Invalid block data
168 Block data not allowed
171 Invalid expression
178 Expression data not allowed
181 Invalid outside macro definition
Error in communication execution
Code Message
221 Setting conflict
222 Data out of range
223 Too much data
224 Illegal parameter value
241 Hardware missing
260 Expression error
270 Macro error
272 Macro execution error
273 Illegal macro label
275 Macro definition too long
276 Macro recursion error
277 Macro redefinition not allowed
278 Macro header not found
708 Cannot output data while measuring
IM 704610-01E
12.2 Error Code Description and Corrective Actions
Description and Corrective Action
<CHARACTER DATA> cannot be used.
Write in a data form other than {...|...|...}.
There is no delimiter to the right of <STRING DATA>.
Enclose <String data> in double quotation or single quotation
marks.
The contents of <STRING DATA> are inappropriate.
<String data> is too long or invalid character is present.
<STRING DATA> cannot be used.
Write in a data form other than <String data> form.
The data length of <BLOCK DATA> does not match.
<Block data> cannot be used.
<BLOCK DATA> cannot be used.
There is an invalid character in the <EXPRESSION DATA>.
Equation cannot be used.
<EXPRESSION DATA> cannot be used.
Equations cannot be used.
The placeholder is outside the macro.
IEEE488.2 macro function is not supported.
Description and Corrective Action
Contradictory settings are in affect.
Check the relevant communication settings.
The value of <DATA> is outside the range. Check the range.
The byte length of <DATA> is too long.
Check the length of data bytes.
The value of <DATA> is inappropriate. Check the range.
Hardware not installed.
Check for the presence or absence of options.
<EXPRESSION DATA> is not correct. Equation cannot be used. —
Macro nesting is too deep.
IEEE488.2 macro function is not supported.
Macros cannot be used.
IEEE488.2 macro function is not supported.
The macro label is inappropriate.
IEEE488.2 macro function is not supported.
Macro is too long. IEEE488.2 macro function is not supported.
Macro was recursively called.
IEEE488.2 macro function is not supported.
Macros cannot be redefined.
IEEE488.2 macro function is not supported.
The macro is not defined.
IEEE488.2 macro function is not supported.
Cannot transmit data while measurement in progress.
Stop the measurement using the STOP or SSTART command.
Ref. section
10.2
10.1
10.2
10.2
10.1, 10.2
10.1, 10.2
10.2
10.2
—
Ref. section
10,2
10,2
10,2
10,2
—
—
—
—
—
—
—
—
12
10.2.13,
10.2.6
12-3