Table of Contents
Advertisement
9.3
Entering the TCP/IP and Timeout Settings, and
Confirming the MAC Address
Procedure
KEY
LOCK
SEC RANGE
IM 704610-01E
Display 2
Display 1
ns ms
s
%
V
%/
S
1.
Press SHIFT+ENTER (UTILITY). The Utility menu is shown on Display 2.
2.
Turn the rotary knob to display Netwrk in Display 2.
3.
Press >. Device, GPIBadd, DHCP, IP add1, IP add2, IP add3, IP add4,
NetMsk1, NetMsk2, NetMsk3, NetMsk4, Gatewy1, Gatewy2, Gatewy3,
Gatewy4, MACadd1, MACadd2, MACadd3, or Timeout is displayed.
Selecting Ethernet Communications
4.
Turn the rotary knob to select Device.
5.
Press > (or ENTER). Display 1 blinks.
6.
Turn the rotary knob to select EtHEr.
7.
Press ENTER.
Turning DHCP ON and OFF
4.
Turn the rotary knob to select DCHP.
5.
Press > (or ENTER). Display 1 blinks.
6.
Turn the rotary knob to select on or oFF.
7.
Press ENTER.
Setting the IP Address
Turn DHCP OFF according to the procedure above before setting the IP address.
4.
Turn the rotary knob to select IP add1, IP add2, IP add3, or IP add4.
The address is expressed using four octets (each from 0 to 255), separated by a period as
in 192.168.111.24. Of these four octets, set the left-most to IP add1, the second one from
the left to IP add2, the third one from the left to IP add3, and the last one on the right to IP
add4.
5.
Press > (or ENTER). Display 1 blinks.
6.
Use rotary knob & < > to set the address.
7.
Press ENTER.
8.
Repeat steps 4 through 7 to enter all the addresses from IP add1 to IP add4.
L.MARK
R.MARK
DISP OFF
MEASURE
E2T
JUDGE
PW
GO
BD x1
D to C
NO-GO
GATE TIME
DELAY
BLOCK
MEDIA
FUNCTION
ARMING
INHIBIT
SHIFT
SHIFT
REMOTE
STORE
UTILITY
10%
LOCAL
RECALL
ENTER
20%
JDG LEVEL
LEVEL
COUPLE
EQ BOOST
S
POLARITY
TRIG
IMPEDANCE EQUALIZER
AUTO
MAN
50 Ω
1M Ω
CONV
SEC RANGE
SCALE
The phrase, "rotary knob & <>"
is used in the following
explanation to instruct the user
to enter numerical setting values
using the knob and arrow keys.
For details on this procedure,
see section 3.7.
9-3
9
Advertisement
Table of Contents
