Keys - YOKOGAWA TA220 User Manual

1.2

Keys

Measurement Condition Settings
L.MARK R.MARK
E2T
PW
BD x1 D to C
GATE TIME DELAY BLOCK
MEDIA FUNCTION ARMING INHIBIT
REMOTE STORE UTILITY
LOCAL RECALL ENTER
JDG LEVEL LEVEL COUPLE EQ BOOST
POLARITY
TRIG IMPEDANCE EQUALIZER
AUTO MAN 50 Ω 1M Ω CONV
1-2
SHIFT+< (L.MARK) key and SHIFT+> (R.MARK) key -> section 4.1
When using the measurement function PW, these key combinations are used to set the
upper and lower limits of the pulse width to be measured.
MEDIA key -> sections 12.4
Press this key during self testing to execute the LED test.
FUNCTION key -> sections 4.1 and 12.4
Selects a measurement function. Also, you can press this key during self testing to
execute the keyboard test.
SHIFT+FUNCTION (GATE TIME) key -> section 4.5
Sets the gate time.
ARMING key -> sections 4.6 and 12.4
Selects either auto arming or external arming. Also, you can press this key during self
testing to execute the meter test.
SHIFT+ARMING (DELAY) key -> section 4.6
Sets the arming delay when external arming is selected.
INHIBIT key -> sections 4.8 and 12.4
Sets inhibit. Also, you can press this key during self testing to execute the board test.
SHIFT+INHIBIT (BLOCK) key -> section 4.7
Sets up block sampling.
POLARITY key -> section 4.1
Selects the polarity of the signal to be measured.
TRIG key -> section 4.4
Selects the trigger mode.
SHIFT+TRIG (LEVEL) key -> section 4.4
Sets the slice level.
IMPEDANCE key -> section 4.2
Selects the input impedance of the measurement input terminal.
SHIFT+IMPEDANCE (COUPLE) key -> section 4.2
Selects the input coupling of the measurement input terminal.
EQUALIZER key -> section 4.3
Equalizes the amplitude of the RF signals input to the measurement input terminal.
SHIFT+EQUALIZER (EQ BOOST) key -> section 4.3
Sets the boost amount of the equalizer.
SHIFT+ENTER (UTILITY) key -> section 4.9
Use to enter PLL hold, D-to-C high speed calculation (not available for products with
suffix code -BDS), AGC, and DC clamp settings.
IM 704610-01E