Figure 5-9 Enabling An Optical Port - Cisco ONS 15327 User Documentation

Chapter 5 SONET Topologies
Click the Provisioning > Line tabs.
Step 3
Step 4 Click Status
Click Apply.
Step 5
Figure 5-9
Repeat Steps 2 – 4 for the other optical card configured as a DCC termination.
Step 6
Step 7 Repeat Steps 2 – 5 at each node that will be in the BLSR.
After configuring the SONET DCC, set the timing for the node. For procedures, see the
15327 Timing" section on page
Procedure: Provision the BLSR
Log into one BLSR node.
Step 1
Select the Provisioning > Ring tabs.
Step 2
Click Create.
Step 3
On the Create BLSR dialog box
Step 4
•
•
June 2002
(Figure 5-9) and choose In Service.
Enabling an optical port
Ring ID—Assign a ring ID (a number between 0 and 9999). Nodes in the same BLSR must have the
same Ring ID.
Node ID—Assign a Node ID. The Node ID identifies the node to the BLSR. Nodes in the same
BLSR must have unique Node IDs (0–31).
3-11. After you configure the timing you can provision the BLSR.
(Figure 5-10), set the BLSR properties:
Cisco ONS 15327 User Documentation, R3.3
Bidirectional Line Switched Rings
"Setting Up ONS
5-9