Cisco ONS 15327 User Documentation page 307

Chapter 9 Ethernet Operation
From the Slot menu, choose the Ethernet card where you enabled the Single-card EtherSwitch and click
Step 13
Next.
The Circuit Creation (Circuit Destination) dialog box appears.
Step 14 Choose the circuit destination from the Node menu.
Choose the node that is not the source.
From the Slot menu, choose the Ethernet card where you enabled the Single-card EtherSwitch and click
Step 15
Next.
The Circuit Creation (Circuit VLAN Selection) dialog box appears
Create the VLAN:
Step 16
Click the New VLAN tab.
a.
The Circuit Creation (Define New VLAN) dialog box appears
Assign an easily identifiable name to your VLAN.
b.
c. Assign a VLAN ID.
This should be the next available number (between 2 and 4093) not already assigned to an existing
VLAN. Each ONS 15327 network supports a maximum of 509 user-provisionable VLANs.
Click OK.
d.
e. Highlight the VLAN name and click the >> button to move the VLAN(s) from the Available VLANs
column to the Circuit VLANs column
Step 17 Click Next.
The Circuit Creation (Circuit Routing Preferences) dialog box appears.
Confirm that the following information about the point-to-point circuit is correct:
Step 18
Circuit name
•
Circuit type
•
Circuit size
•
VLANs that will be transported across this circuit
•
• ONS 15327 nodes included in this circuit
Note
Click Finish.You must now provision the second circuit and attach it to the already-created VLAN.
Step 19
Step 20 Log into the ONS 15327 Ethernet circuit endpoint for the second circuit.
Step 21 Double-click the Ethernet card that will create the circuit. The CTC card view displays.
Click the Provisioning > Card tabs.
Step 22
Under Card Mode, check Single-card EtherSwitch.
Step 23
If the Single-card EtherSwitch check box is not checked, check it and click Apply.
Log into the other ONS 15327 endpoint for the second circuit and repeat Steps 21–23.
Step 24
Display the CTC node view.
Step 25
Click the Circuits tab and click Create.
Step 26
June 2002
If the circuit information is not correct, click the Back button and repeat the procedure with the
correct information. You can also click Finish, delete the completed circuit, and start the
procedure from the beginning.
(Figure 9-8 on page
(Figure 9-10 on page
(Figure 9-10 on page 9-9).
Cisco ONS 15327 User Documentation, R3.3
Ethernet Circuit Configurations
9-8).
9-9).
9-15