Not-Authenticated; Pdi-P - Cisco ONS 15327 User Documentation
Hide thumbs
Also See for ONS 15327:
- Procedure manual (478 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 14
Alarm Troubleshooting
The ONS 15327 boots up the second XTC card. The second XTC must also copy the system software,
which can take up to twenty minutes.
Step 8
If the MFGMEM alarm continues to report after replacing the XTC cards, the problem lies in the
EPROM.
Step 9
If the MFGMEM is reported from the fan tray, replace the fan tray.
If the MFGMEM is reported from the AIP, the backplane, or the alarm persists after the fan tray is
Step 10
replaced, login to http://www.cisco.com/TAC for more information or call the Cisco Technical
Assistance Center (1-800-553-2447).
14.4.91 NOT-AUTHENTICATED
•
This not authenticated (NOT-AUTHENTICATED) alarm indicates that the username and password
entered do not match the information stored in the XTC. All ONS nodes must have the same username
and password created to display every ONS node in the network. You can also be locked out of certain
ONS nodes on a network if your username and password were not created on those specific ONS nodes.
Note
For initial logon to the ONS 15327, type the user name
required).
Procedure: Clear the NOT-AUTHENTICATED Alarm on the XTC Card
If you have an alternate username and a password available to access the system:
Step 1
a.
b.
c.
d.
e.
f.
Step 2
If you do not have an alternate username and password available, lo on to http://www.cisco.com/TAC for
more information or call the Cisco Technical Assistance Center to report a service-affecting problem
(1-800-553-2447). TAC can issue a new username and password.
14.4.92 PDI-P
•
June 2002
Minor, Non-Service-Affecting
Use the alternate username and password to access the ONS node.
Click the Provisioning > Security tabs.
Look under the Users field to find the username that raised the alarm.
If the username that raised the alarm is listed, then highlight the username to reveal the associated
password. Record the correct password.
If the username is not listed, then click Create.
Fill in the fields on the Create User dialog box with the username and password that raised the alarm
then click OK.
Not Alarmed (NA) (Condition)
and click Login (no password is
CISCO15
Cisco ONS 15327 User Documentation, R3.3
Alarm Procedures
14-65
Advertisement
Table of Contents
