Creating Protection Groups
Figure 3-3
In the Protection Groups section, choose a protection group.
Step 2
In the Selected Group section, edit the fields as appropriate. (For field descriptions, see the
Step 3
Protection Groups for Optical Cards" procedure on page
Click Apply.
Step 4
Procedure: Delete Protection Groups
Step 1
From the CTC node view, click the Maintenance > Protection tabs.
Verify that working traffic is not running on the protect card:
Step 2
a.
b.
c.
From the node view, click the Provisioning > Protection tabs.
Step 3
Step 4
In the Protection Groups section, click a protection group.
Click Delete.
Step 5
Cisco ONS 15327 User Documentation, R3.3
3-10
Editing protection groups
In the Protection Groups section, choose the group you want to delete.
In the Selected Group section, verify that the protect card is in standby mode. If it is in standby
mode, continue with Step 3. If it is active, complete Step c.
If the working card is in standby mode, manually switch traffic back to the working card. In the
Selected Group pane, click the protect card, then click Manual. Verify that the protect card switches
to standby mode and the working card is active. If it does, continue with Step 3. If the protect card
is still active, do not continue. Begin troubleshooting procedures or call technical support.
Chapter 3
3-8.)
Node Setup
"Create
June 2002