Table 2-3 Ons 15327 Connection Methods - Cisco ONS 15327 User Documentation

Running the CTC Installation Wizard
Table 2-3
Method
Local craft Refers to onsite network connections
Corporate
LAN
TL1
Remote
After you have determined which method you will use to connect to the ONS 15327, find the necessary
procedures in
Cisco ONS 15327 User Documentation
2-10
ONS 15327 Connection Methods
Description
between the CTC computer and the
ONS 15327 using:
The RJ-45 jack on the XTC, or
•
A hub or switch to which the ONS 15327
•
is connected.
Refers to a connection to the ONS 15327
through a corporate or NOC LAN.
Refers to a connection to the ONS 15327
using TL1 rather than CTC. TL1 sessions can
be started from CTC, or you can use a TL1
terminal. The physical connection can be a
craft connection, corporate LAN, or a TL1
terminal. Refer to the Cisco ONS 15454 and
Cisco ONS 15327 TL1 Command Guide.
Refers to a connection made to the
ONS 15327 using a modem.
Table 2-4.
Chapter 2 Software Installation
Requirements
If you do not use DHCP, you will need
•
to change the computer IP address,
subnet mask, and default router.
• The ONS 15327 must be provisioned
for LAN connectivity, including IP
address, subnet mask, and default
gateway.
The ONS 15327 must be physically
•
connected to the corporate LAN.
The CTC computer must be connected
•
to the corporate LAN that has
connectivity to the ONS 15327.
• A modem must be connected to the
ONS 15327.
• The modem must be provisioned for
ONS 15327. To run CTC, the modem
must be provisioned for Ethernet
access.
June 2002