Figure 9-17 Selecting Vlans - Cisco ONS 15327 User Documentation

Ethernet Circuit Configurations
Create the VLAN:
Step 16
a. Click the New VLAN tab.
The Circuit Creation (Define New VLAN) dialog box appears
Assign an easily identifiable name to your VLAN.
b.
Assign a VLAN ID.
c.
The VLAN ID should be the next available number (between 2 and 4093) that is not already assigned
to an existing VLAN. Each ONS 15327 network supports a maximum of 509 user-provisionable
VLANs.
Click OK.
d.
Highlight the VLAN name and click the arrow >> button to move the VLAN(s) from the Available
e.
VLANs column to the Circuit VLANs column

Figure 9-17 Selecting VLANs

Click Next.
Step 17
The Circuit Creation (Circuit Routing Preferences) dialog box appears.
Confirm that the following information is correct:
Step 18
Circuit name
•
Circuit type
•
Circuit size
•
VLANs on this circuit
•
ONS 15327 nodes included in this circuit
•
Note
Click Finish.
Step 19
Step 20 You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning
instructions, see the
assigning ports to VLANs, see the
page 9-25.
After assigning the ports to the VLANs, repeat Steps
Step 21
cross-connect endpoint.
Cisco ONS 15327 User Documentation, R3.3
9-18
If the circuit information is not correct, click the Back button and repeat the procedure with the
correct information. You can also click Finish, delete the completed circuit and start the
procedure from the beginning.
"Provision E10/100-4 Ethernet Ports" procedure on page
(Figure 9-17).
"Provision Ethernet Ports for VLAN Membership" procedure on
1–19 at the second ONS 15327 Ethernet manual
Chapter 9 Ethernet Operation
(Figure 9-10 on page 9-9).
9-3. For information about
June 2002