Enable Ports; Edit Protection Groups - Cisco ONS 15327 User Documentation

Chapter 3 Node Setup
•
•
Step 7 Click OK.
The default XTCPROTGRP provides XTC-level protection for DS-1 and DS-3 ports. It is non-revertive
Note
and cannot be modified or deleted.
Procedure: Enable Ports
Log into the node in CTC and display the card you want to enable in card view.
Step 1
Step 2 Click the Provisioning > Line tabs.
Under the Status column, select In Service.
Step 3
Click Apply.
Step 4
Procedure: Edit Protection Groups
From the CTC node view, click the Provisioning > Protection tabs
Step 1
June 2002
Revertive—if checked, the ONS 15327 reverts back to the working port after failure conditions are
corrected.
Reversion time—if Revertive is checked, enter the amount of time following a corrected failure
condition that the ONS 15327 should switch back to the working port.
Creating Protection Groups
(Figure 3-3).
Cisco ONS 15327 User Documentation, R3.3
3-9