Cisco ONS 15327 User Documentation page 38

Procedures
Select Fifteen-Minute PM Intervals on the Performance Monitoring Screen
Select Twenty-Four Hour PM Intervals on the Performance Monitoring Screen
Clearing PM Data on the Performance Monitoring Screen
Select Near End PMs on the Performance Monitoring Screen
Select Far End PMs on the Performance Monitoring Screen
Select Signal-Type Menus on the Performance Monitoring Screen
Use the Baseline Button on the Performance Monitoring Screen
Use the Clear Button on the Performance Monitoring Screen
Ethernet Operation
Provision E10/100-4 Ethernet Ports
Provision an EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)
Provision a Shared Packet Ring
Provision a Hub and Spoke Ethernet Circuit
Provision a Single-card EtherSwitch Manual Cross-Connect
Provision a Multicard EtherSwitch Manual Cross-Connect
Provision Ethernet Ports for VLAN Membership
Enable Spanning Tree on Ethernet Ports
View the Spanning Tree Map
Retrieve the MAC Table Information
Creating Ethernet RMON Alarm Thresholds
Alarm Monitoring and Management
SNMP
Maintenance
Inspect and Clean the Reusable Air Filter
Replace the Fan-Tray Assembly
Perform a Software Reset
Perform a Card Pull
Backup the Database
Restore the Database
Revert to an Earlier Software Load
Perform a Span Upgrade Using the Span Upgrade Wizard
Perform a Manual Span Upgrade on a Two-Fiber BLSR
Perform a Manual Span Upgrade on a UPSR
Cisco ONS 15454 Installation and Operations Guide, R3.2
xxxvi
9-3
9-10
9-14
9-27
9-28
9-31
9-33
12-2
12-3
12-5
12-5
12-7
12-7
12-9
12-16
8-5
8-6
8-7
8-8
8-9
8-10
9-7
9-17
9-19
9-25
12-13
12-15
8-4
8-5
June 2002