Figure 9-7 Single-Card Etherswitch Point-To-Point Circuit - Cisco ONS 15327 User Documentation

Chapter 9 Ethernet Operation
Figure 9-7
192.168.1.25
255.255.255.0
VLAN test
Procedure: Provision an EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)
Display CTC for one of the ONS 15327 Ethernet circuit endpoint nodes.
Step 1
Double-click one of the Ethernet cards that will carry the circuit.
Step 2
Step 3 Click the Provisioning > Card tabs.
If you are building a Multicard EtherSwitch point-to-point circuit:
Step 4
a.
b.
c.
If you are building a Single-card EtherSwitch circuit:
a.
b.
Step 5 Navigate to the other ONS 15327 Ethernet circuit endpoint.
Repeat Steps 2–5.
Step 6
Step 7 Click the Circuits tab and click Create.
The Circuit Creation (Circuit Attributes) dialog box appears.
In the Name field, type a name for the circuit.
Step 8
From the Type pull-down menu, choose STS.
Step 9
The VT and VT Tunnel types do not apply to Ethernet circuits.
Note
Step 10 Choose the size of the circuit from the Size pull-down menu.
The valid circuit sizes for an Ethernet Multicard circuit are STS-1 and STS-3c.
The valid circuit sizes for an Ethernet Single-card circuit are STS-1, STS-3c, STS-6c and STS-12c.
Verify that the Bidirectional check box is checked and click Next.
Step 11
The Circuit Creation (Circuit Source) dialog box appears
June 2002
Single-card EtherSwitch point-to-point circuit
ONS Node
#2
Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
If Multi-card EtherSwitch Group is not checked, check it and click Apply.
Repeat Steps 2–4 for all other Ethernet cards in the ONS 15327 that will carry the circuit.
Under Card Mode, verify that Single-card EtherSwitch is checked.
If Single-card EtherSwitch is not checked, check it and click Apply.
ONS Node
#1
ONS Node
#3
(Figure
Cisco ONS 15327 User Documentation, R3.3
Ethernet Circuit Configurations
192.168.1.50
255.255.255.0
VLAN test
9-8).
9-7