Figure 9-19 Selecting Vlans - Cisco ONS 15327 User Documentation

Ethernet Circuit Configurations
Verify that the Bidirectional check box is checked and click Next.
Step 11
The Circuit Creation (Circuit Source) dialog box appears.
From the Node menu, choose the current node as the circuit source.
Step 12
Choose Ethergroup from the Slot menu and click Next.
Step 13
The Circuit Creation (Circuit Destination) dialog box appears.
From the Node menu, choose the current node as the circuit destination.
Step 14
Choose Ethergroup from the Slot menu and click Next.
Step 15
Note
The Circuit Creation (Circuit VLAN Selection) dialog box appears
Create the VLAN:
Step 16
Click the New VLAN tab.
a.
The Circuit Creation (Define New VLAN) dialog box opens
Assign an easily identifiable name to your VLAN.
b.
Assign a VLAN ID.
c.
The VLAN ID should be the next available number (between 2 and 4093) that is not already assigned
to an existing VLAN. Each ONS 15327 network supports a maximum of 509 user-provisionable
VLANs.
Click OK.
d.
e. Highlight the VLAN name and click the arrow >> button to move the VLAN(s) from the Available
VLANs column to the Circuit VLANs column

Figure 9-19 Selecting VLANs

Click Next.
Step 17
The Circuit Creation (Circuit Routing Preferences) dialog box appears.
Confirm that the following information is correct:
Step 18
Circuit name
•
Circuit type
•
Circuit size
•
• VLANs on this circuit
Cisco ONS 15327 User Documentation, R3.3
9-20
For the Ethernet manual cross-connect, the destination and source should be the same node.
Chapter 9
(Figure 9-10 on page
(Figure 9-9 on page
(Figure 9-19).
Ethernet Operation
9-9).
9-8).
June 2002