Cisco ONS 15327 User Documentation page 27

Figure 9-2 E10/100-4 Ethernet card faceplate
Figure 9-3 Provisioning E10/100-4 Ethernet ports
Figure 9-4 A Multicard EtherSwitch configuration
Figure 9-5 A Single-card EtherSwitch configuration
Figure 9-6 Multicard EtherSwitch point-to-point circuit
Figure 9-7 Single-card EtherSwitch point-to-point circuit
Figure 9-8 Choosing a circuit source
Figure 9-9 Choosing a VLAN name and ID
Figure 9-10 Selecting VLANs
Figure 9-11 Shared packet ring Ethernet circuit
Figure 9-12 Adding a span
Figure 9-13 Viewing a span
Figure 9-14 A Hub and spoke Ethernet circuit
Figure 9-15 Ethernet manual cross-connects
Figure 9-16 Creating an Ethernet circuit
Figure 9-17 Selecting VLANs
Figure 9-18 Creating an Ethernet circuit
Figure 9-19 Selecting VLANs
Figure 9-20 A Q-tag moving through a VLAN
Figure 9-21 Priority queuing process
Figure 9-22 Configuring VLAN membership for individual Ethernet ports
Figure 9-23 STP-blocked path
Figure 9-24 The Spanning-tree map on the circuit window
Figure 9-25 MAC addresses recorded in the MAC table
Figure 9-26 Creating RMON thresholds
Figure 10-1 Viewing alarms in CTC node view
Figure 10-2 Selecting the Affected Circuits Option
Figure 10-3 Highlighted circuit appears
Figure 10-4 Viewing fault conditions under the Conditions Tab
Figure 10-5 Viewing all alarms reported for the current session
Figure 10-6 Network View Alarm Profiles subtab showing the default profiles of listed alarms
Figure 10-7 Node view Alarm Behavior subtab of an OC-12 alarm profile
Figure 10-8 Card view Alarm Behavior subtab of an OC-12 alarm profile
Figure 10-9 The suppress alarms check box
Figure 11-1 A basic network managed by SNMP
June 2002
9-2
9-3
9-4
9-5
9-8
9-8
9-9
9-10
9-12
9-13
9-14
9-16
9-17
9-18
9-19
9-20
9-23
9-24
9-26
9-33
10-2
10-4
10-4
10-12
11-2
9-6
9-7
9-25
9-28
9-31
10-5
10-7
10-10
10-11
Cisco ONS 15327 User Documentation
Figures
10-8
xxv