Recommended Tools - Epson SC-F9200 Series Service Manual

SC-F9200 Series

3.1.4 Recommended Tools

To protect this product from damage, use the tools indicated in the following table.
For the tools required to perform the adjustment, refer to "Tools/Consumables for
Adjustments" in Chapter 4.
Table 3-1. Tools
Name Description
4 cm or longer shaft length (The
Phillips screwdriver, No. 1 one with a magnet is
recommended)
28 cm or longer shaft length (The
one with a magnet is
recommended)
Phillips screwdriver, No. 2
Stubby driver with 4 cm or shorter
shaft length (The one with a
magnet is recommended)
Short type with a 20-mm or shorter
Ratchet screwdriver
head
Tweezers Nothing in particular
C-ring pliers To remove C-rings (φ25).
To secure the cable/harness, or for
Acetate tape the protection against the sharp
edge
To prevent staining the printer
Waste cloth
with ink during operation
Recommend the below for insure
accuracy
Rule Scale 
SHINWA Round End Stainless
Rule : 1m
Item code : 13048(21108)
Recommend the below for insure
L-shaped Offset
accuracy
Screwdriver

VESSEL No.TD-61
DISASSEMBLY & ASSEMBLY
Precision Screwdriver
Long nose pliers
Target Part

Print Head

Some encoders/sensors
Parts in general

APG Unit

Ink Tank/Cartridge

Driven Roller Gear
Parts in general
Roll Paper Holder
Parts in general (Use this tape
when it is removed or when
replacing the part)

Ink Tube

Ink Holder

Flushing Box

Duct CR

Print Head

Pump Cap Unit
Parts in general

PF Roller Center Support
Overview
Table 3-1. Tools
Name Description
Nothing in particular
Nothing in particular
SE Group Confidential (Related Staff Only)
Revision B
Target Part

PF Roller Center Support

PF Roller Center Support
80