Epson SC-F9200 Series Service Manual page 132

SC-F9200 Series
3.4.4.5 Sub-D Board
1. Remove the Media Loading Lever.
2. Remove the Panel Unit. (p101)
3. Remove the Right Upper Cover.
(p110)
4. Remove the Left Rear Cover.
(p111)
5. Remove the Left Upper Cover.
(p116)
6. Remove the Upper Cover.
7. Remove the pieces of acetate tape, and release the cover from the two hooks on the
frame.
Acetate tape
Figure 3-61. Removing the Cover
DISASSEMBLY & ASSEMBLY
(p210)
(p103)
Cover
Hook
Sub-D Board
Hook
Acetate tape
Disassembly and Assembly Procedure
8. Disconnect all FFCs from the Sub-D Board.
9. Remove the four screws, and remove the Sub-D Board.
A) Silver M3x8 S-tite screw: 4 pcs
When installing the Sub-D Board, make sure to install it in the
correct orientation as shown in Figure3-62.
Sub-D Board
A
A
Figure 3-62. Removing the Sub-D Board
SE Group Confidential (Related Staff Only)
Revision B
A
A
Rear Side
132