Ink Tank Replacement - Epson SC-F9200 Series Service Manual

SC-F9200 Series

4.12.8 Ink Tank Replacement

REQUIRED TOOLS
 New Ink pack and Chip unit that is attached New Ink pack
 New Ink Tank
EXECUTION MODE
Normal Mode
PROCEDURE
1. Turn on the printer.
2. Take a picture of control panel. If you don't have camera, see the charge status and
reservation status on the control panel and write them down.(Refer to
4-52.)
3. Turn off the printer.
4. Remove the old Ink Tank and old chip unit which is attached on the tank.
C H E C K
Don't dispose the old chip unit because you may use it on
P O I N T
reserve.
5. Install the new Ink Tank.
6. Install the new chip unit is attached New Ink pack.
7. Turn on the printer.
8. Check the reservation status where you replaced the Ink Tank.

If the chip is reserved.
Start the Service Program and select
Force charge (p.329)
(Refer to

If the chip is Not reserved.
Proceed Step9.(Because reservation chip has been already charged
automatically.)
ADJUSTMENT
Figure
Step9
Force charge.
)
Ink Supply Related Checks and Adjustments
9. Refer to the picture which you took on
each color.

Color which is reserved before replacing tank
Install the old chip unit which you remove on

Color which is Not reserved before replacing tank
You don't need to attach the old chip.
10. Refill the new Ink into new tank.
11. Start the Service Program and select
replacing old ink tanks with new ones
12. Turn the printer OFF to complete the adjustment.
to
Step2 and check the reservation status for
Step4 to reserve.
Initial ink charge. (Refer to When
in Initial Ink Charge (p.334))
SE Group Confidential (Related Staff Only)
Revision C
337