When Left Unused/Transportation; When Left Unused - Epson SC-F9200 Series Service Manual

SC-F9200 Series

5.3 When left unused/transportation

5.3.1 When left unused

The following should be carried out if the printer is not used more than two weeks.
5.3.1.1 Preparation before leaving printer unused
REQUIRED TOOLS
 Stubby screwdriver
 Screwdriver
 Cleaning cartridge (x8)
 USB cable
 Service program
 Communication Driver
PROCEDURE
1. Turn on the printer.
C H E C K
If some of the chip units is reserved, return them to the customer.
P O I N T
(Because they can be used.)
2. Discard the waste ink.
3. Select Procedure (Before no using printer over spec)
(Sequence).
4. Select Auto CR unlock & move CR to full column
Press the [Run] button.
The CR lock is released and the CR Unit moves to the full side, then the printer
turns off automatically.
5. Clean where ink attaches to the parts such as around the print head, cap, wiper and
wiper rail.
MAINTENANCE
6.
7.
8.
9.
10. Select
11. Turn off the printer.
12. Install the cleaning cartridges.
13. Lower all the lock levers.
14. Turn on the printer.
15. Discard the waste ink.
16. Select
17. Discard the waste ink.
18. Reset the
19. Turn off the printer.
20. Install the new ink tanks to prevent the foreign materials from intruding the ink
from ADJUSTMENT
side.
When left unused/transportation
Remove all the ink tanks and chip units and discard them.
Lower all the lock levers.
Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
Select Ink eject.
Select All channels, and press the [Run]
Activation of Cleaning cartridge.
All channels, and press the [Run] button to make the cleaning cartridge available.
(Page 331)
(Page 207)
Tube inner cleaning.
Select All channels, and press the [Run]
(Page 333)
Waste Ink Bottle Counter.
holder during transferring/left unused.
SE Group Confidential (Related Staff Only)
Revision B
(Page 207)
button to run the ink eject. (Page 332)
button to charge the cleaning liquid.
(Page 207)
368