Disassembly And Assembly Procedure; Preparation For Servicing - Epson SC-F9200 Series Service Manual

SC-F9200 Series

3.4 Disassembly and Assembly Procedure

This section describes procedures for disassembling the components allowed to be
disassembled. Unless otherwise specified, disassembled units or components can be
reassembled by reversing the disassembly procedure.

3.4.1 Preparation for Servicing

3.4.1.1 Unlocking the CR Unit
When you have unlocked the CR Unit and finished your
C A U T I O N
reassembly work, move the CR Unit (Print Head) over the platen
and turn the printer on to let it perform the initialization sequence.
(By this sequence, the CR Unit is locked and Print Head is capped.)
If the initialization is performed on or over the Cap, the Print Head
may be damaged.
DISASSEMBLY & ASSEMBLY
 Manual
1. Remove the Right Maintenance Cover.
2. Remove the screw, and remove the cover.
A) Silver M3x8 P-tite screw with captive washer: 1 pcs
3. Insert a screwdriver into the hole shown as "Insert driver (A)" in the figure.
4. While viewing the CR Lock Lever status from the front of the printer, turn the
screwdriver counterclockwise until the CR Lock Lever moves to the CR unlocked
position.
5. The CR Lock Lever is lowered. Check that the lever reaches the CR unlock
position, and stop turning the white shaft.
C A U T I O N
C H E C K
P O I N T
6. Insert a screwdriver into the hole shown as "Insert driver (B)" in the figure.
7. Move the CR Lock Lever to the CR unlocked position in the same way as step 4.
C A U T I O N
Disassembly and Assembly Procedure
Do not turn the screwdriver clockwise.

When the CR is unlocked, it clicks.

Use a screwdriver with a 280 mm or longer shaft.
Make sure to first unlock the carriage from the "Insert driver (A)"
hole. If you insert a screwdriver into the (B) hole first, it may result
in damaging the tubes inside the printer. Accessing from (A)
unlocks pump cap 2, and accessing from (B) unlocks pump cap 1.
SE Group Confidential (Related Staff Only)
Revision B
98