SC-F9200 Series
3.4.6.12 PF Roller Center Support
To shorten the repair time,
C H E C K
P O I N T
(However, if the steps above are omitted, the inside of the printer
becomes darker, so the work may be difficult.)
1.
Open the Front Cover.
When removing the screws, make sure to pinch the precision
C A U T I O N
screwdriver with long nose pliers.
Long nose pliers
2.
Remove the forty screws and remove the Rib on the Platen.
A) Silver M2.6x6 flat head screw: 40 pcs
Remove the screw of Rib by precision screwdriver.
C H E C K
P O I N T
Referring to following "Removing position of Rib" when
remove the screw of Rib.
DISASSEMBLY & ASSEMBLY
Step 1
to
Step 5
can be omitted.
Precision Screwdriver
1, 4, 8, 12, 16, 20, 23
1, 4, 8, 12, 16, 20, 23
Disassembly and Assembly Procedure
Do not touch the CR Scale.
C A U T I O N
3.
Remove the six screws that secure the After Heater.
B) Silver M3x8 S-tite screw: 6 pcs
4.
Shift the After Heater forward and make a space between Platen and After Heater.
Rib
7
7
A
Rib
A
A
A
Figure 3-177. Removing the Rib
SE Group Confidential (Related Staff Only)
Revision B
A
A
Upper
A
Lower
227