Overview; Precautions; Recommended Tools - Epson Stylus Photo R220 Service Manual

EPSON Stylus Photo R220/R230

2.1 Overview

This chapter describes the procedure for disassembling and reassembling the main
components of the Stylus Photo R220/R230. Unless otherwise specified, disassembled
units or components can be reassembled by reversing the disassembly procedure.
Procedures which, if not strictly observed, could result in personal injury are described
under the heading "WARNING".
"CAUTION" signals a precaution which, if ignored, could result in damage to
equipment.
Important tips for procedures are described under the heading "CHECK POINT".
If the assembly procedure is different from the reversed disassembly procedure the
correct procedure is described under the heading "REASSEMBLY."
Any adjustments required after reassembly of components or parts are described under
the heading "ADJUSTMENT REQUIRED".
When you have to remove any parts or components that are not described in this
chapter, refer to the exploded diagram in the Appendix.
Read the next section "Precautions" fully before starting disassembly.

2.1.1 Precautions

Before starting the disassembly or reassembly of the product, read the following
precautions given under the headings WARNING and CAUTION.
Disconnect the power cable before disassembling or assembling
W A R N I N G
the printer.
If you need to work on the printer with power applied, strictly
follow the instructions in this manual.
Wear protective goggles to protect your eyes from ink. If ink gets
in your eye, flush the eye with fresh water and see a doctor
immediately.
Always wear gloves for disassembly and reassembly to avoid
injury from sharp metal edges.
To protect sensitive microprocessors and circuitry, use static
discharge equipment, such as anti-static wrist straps, when
accessing internal components.
Never touch the ink or wasted ink with bare hands. If ink comes
into contact with your skin, wash it off with soap and water
immediately. If you have a skin irritation, consult a physician.
When reassembling the waste ink pads and tray, always make
sure that the waste ink tube is fitted correctly in the specified
place. Fitting the ink tube in other than the specified position can
cause ink leakage.
DISASSEMBLY / ASSEMBLY
When transporting the printer after installing the ink cartridge,
C A U T I O N
pack the printer for transportation without removing the ink
cartridge and be sure to secure the Ink Cartridge to the printer
cover with tape tightly to keep it from moving.
Use only recommended tools for disassembling, assembling or
adjusting the printer. (Refer to Table 2-1 "Tool List".)
Observe the specified torque when tightening screws.
Use the specified lubricants and adhesives. (Refer to Chapter 4
for details.)
Make the specified adjustments when you disassemble the
printer. (Refer to Chapter 3 for details.)
When using compressed air products; such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.

2.1.2 Recommended Tools

Use only specified tools to avoid damaging the printer.
Tool Name
Phillips Screw Driver (No. 0)
Phillips Screw Driver (No. 1)
Phillips Screw Driver (No. 2)
Tweezers
Acetate Tape
Hexagonal Box driver (5.5mm)
Overview
Table 2-1. Tools
Supplier Code
EPSON 1080531
EPSON 1080530
EPSON 1080532
EPSON 1080561
EPSON 1003963
EPSON 1080584
Revision A
41