Epson SC-F9200 Series Service Manual page 213

SC-F9200 Series
3.4.6.3 PF Motor
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
(p110)
1. Remove the Left Rear Cover.
(p111)
2. Remove the Left Upper Cover.
(p114)
3. Remove the Left Cover.
4. Disconnect the PF Motor Cables from the relay connector.
5. Release the PF Motor Cables from the two clamps.
- Rear side -
Relay Connector
PF Motor Cable
Clamps
Figure 3-162. Releasing the Cable
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
PF Motor
Disassembly and Assembly Procedure
6. Loosen the two screws (A) that secure the PF Motor Mounting Plate.
Before tightening the screw A, move the PF Motor Mounting Plate
frontward and rearward several times, and make sure that the
plate moves smoothly and tension of the tension spring is applied
properly.
7. While pressing the mounting plate in the direction of the arrow, loosen the tension
of the PF Timing Belt, and remove the belt from the pinion gear of the PF Motor.
8. Remove the two screws, and remove the PF Motor.
E) Silver M3x6 screw with built-in washer: 2 pcs
Tension Spring
PF Motor
B
A
PF Motor
Mounting Plate
Figure 3-163. Removing the PF Motor
SE Group Confidential (Related Staff Only)
Revision B
PF Timing Belt
A
B
Pinion gear
213