Epson SC-F9200 Series Service Manual page 371

SC-F9200 Series
5.3.2.2 Preparation after transportation (Without replacing Ink
Tanks)
REQUIRED TOOLS
 Stubby screwdriver
 Screwdriver
 Brand-new ink tank (x8)
 Brand-new chip unit (x8)
 Media (for nozzle checking)
 Service program
 Communication Driver
PROCEDURE
C H E C K
Within two weeks since the preparation, install the ink tank and
P O I N T
chip unit previously used.
If two weeks or more has passed since the preparation before
transportation was carried out, Refer to
transportation (With replacing Ink Tanks) (p.372)
1. Remove all the cleaning cartridges.
2. Lower all the lock levers.
3. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
MAINTENANCE
Preparation after
(Page 207)
When left unused/transportation
4. Start the service program and select
without replacement Ink Tank)
5. Select Switch between Ink cartridges and Ink
Select All channels and Ink Tank, and press the
tank available. (Page 329)
6. Turn off the printer.
7. Install the ink tanks. (Page 207)
8. Install the chip units, and pour ink.
C H E C K
Install the ink tank and chip unit previously used.
P O I N T
9. Turn on the printer.
10. Discard the waste ink.
11. Select Initial ink charge.
Select All channels, and press the
(Page 334)
12. Select Nozzle Check.
Select Nozzle Check Pattern Print, and press the
check. (Page 311)
13. Perform cleaning if necessary. (Page 313)
SE Group Confidential (Related Staff Only)
Revision B
Treatment for transfer (After transfer
from ADJUSTMENT (Sequence).
tanks.
[Run] button to make the ink
[Run] button to run the initial ink charge.
[Run] button to run the nozzle
371