Epson SC-F9200 Series Service Manual page 119

SC-F9200 Series
8. Remove the screw that secures the R Maintenance Cover Sensor.
A) Silver M3x8 P-tite screw with built-in washer: 1 pcs
9. Pull out the cable through the three holes on the frame.
10. Release the cable from the cable guide of the Right Front Cover, and remove the R
Maintenance Cover Sensor.

When installing the R Maintenance Cover Sensor, properly
engage its two dowels and one hook with the three positioning
holes on the Right Front Cover.

Route the sensor cable through the cable guide correctly.
DISASSEMBLY & ASSEMBLY
- Right front side -
Holes
Hole
Right Front Cover
Disassembly and Assembly Procedure
Dowel
Hook
R Maintenance Cover
Sensor Cable
R Maintenance Cover Sensor
Figure 3-40. Removing the R Maintenance Cover Sensor
SE Group Confidential (Related Staff Only)
Revision B
Cable Guide
A
Dowel
119